Graphics Reference
In-Depth Information
C H A P T E R 9
■ ■ ■
Advanced Cuts and Drilling IV
Four more pieces to cut and drill—that's all that is left before you can begin the assembly of your 3D
printer and start adding in the electronics and other hardware. This chapter will walk you through that
last bit of work. Let's get started!
Extruder Bearing Hinge 1 - Part P
The Extruder Bearing Hinge consists of two pieces. Part P is the Extruder Bearing Hinge 1, and its
starting dimensions should be 1-13/16” x 3-17/32” (verify these dimensions with the full-sized plans).
Figure 9-1 shows Part P marked for drilling. Drill the first counterbore hole to a diameter of 1-1/2” and a
depth of 3/8” (half the thickness of the plywood).
 
Search WWH ::




Custom Search