Graphics Reference
In-Depth Information
Figure 8-10. Part R in plywood (on bottom) and MDO (on top)
Table Bearing Supports - Parts I and J
Parts I and J, the Table Bearing Supports, are two of the oddest looking pieces that you'll be cutting and
drilling. We actually used rulers to take accurate measurements from the full-sized building instructions
just to be certain about the placement of the cuts and holes. Fortunately, these pieces are small and easy
to make, even thought they might look difficult. In fact, you can clamp or tape them together to drill and
cut them simultaneously. Figure 8-11 shows the two pieces taped together and ready for drilling.
Search WWH ::
Custom Search