Graphics Programs Reference
In-Depth Information
50. Select the two endpoints shown in Fig-
ure 14-65 and create a new spline.
Then use the Add Points tool to add a
central control point. Use the Drag tool
in the Back viewport to move this point
to the left slightly, creating a subtle arc
in the neck.
We have a nearly perfect quad cage, but the
back of the head and the neck are com-
prised of areas that are much larger than
the rest of our cage. We must not forget Tip
#3! These areas should be divided into
smaller sections so that the same patch set-
tings can be used on the entire model.
Figure 14-65
Figure 14-66: Keeping Tip #3 in mind, we must section off these large
areas by creating a new spline.
