Graphics Programs Reference
In-Depth Information
Figure 14-41: This small spline defines the corner of the mouth.
Figure 14-42
32. Create two additional points as shown
in Figure 14-42. Then select the points
shown and create a new spline. This
will be the bottom of our quad cage.
By adding these two splines, we've created
the inside boundaries for our face, but we're
now in violation of Tips 2 and 3. The area
over the nose and cheek is much larger
than the other regions in our cage, and the
area around the jaw consists of more than
four splines. We need to address each of
these issues.
33. Select the existing points under the
nose and over the cheek as shown in
Figure 14-43 and create a new spline.
(If you don't have the points needed to
