Graphics Programs Reference
In-Depth Information
Choose
Extrude
from the shortcut menu; the
Extrude
tool settings are displayed in the
Attribute Manager. In the
Extrude
tool settings area, set the value
400
in the
Offset
slider and then press the ENTER key. Set the value
4
in the
Subdivision
slider and then
press the ENTER key.
After entering the value, the selected polygons are extruded in the Perspective viewport, as
shown in Figure 3-71.
Figure 3-71
The selected polygons extruded in the Perspective viewport
Creating the Support for the CPU
In this section, you will create the support for the CPU.
1. Choose the
Edges
tool from the Modes Palette; the
Computer table
is displayed in
the edge mode. Right-click in the Perspective viewport
;
a shortcut menu is displayed.
Choose
Knife
from the shortcut menu; the
Knife
tool settings are displayed in the
Attribute Manager. Make sure
Loop
is selected in the
Mode
drop-down list and the
Restrict to Selection
check box is cleared.
2. Make sure the
Enable Snap
tool is deactivated in the Modes Palette. Next, click on an
edge, as shown in Figure 3-7
2
; a new edge loop is added to
Computer table.
Search WWH ::
Custom Search