Civil Engineering Reference
In-Depth Information
Exercise 2 solution 2
A1
J
I
6
6
781
M
K
Material
Body
Flange
Stainless steel
6
mm
20
mm
A1
L
17.7
Exercise 2 solution 2 (dimensions are in millimetres).
Comments
In
Fig. 17.7
:
I
replaces
A
in Fig. 17.2 on page 45. The weld symbol, consisting
of two parallel lines, is designated a surface joint in ISO 2553,
with an illustration that appears to represent a stud weld on a
plate. The application of the symbol is assumed to be as shown.
J
replaces
B
in Fig. 17.2 on page 45. Note that ISO 2553 does not
have a symbol for NDT and uses a reference in the tail to indi-
cate that instructions are given in a note on the drawing or in a
Welding Procedure Specification (WPS). There is no melt
through symbol in ISO 2553 and full penetration of a butt weld
is always assumed, which would produce a penetration bead.
The flat contour symbol is used by ISO without any indication
