Civil Engineering Reference
In-Depth Information
Exercise 2 solution 1
F
G
6
6
E
H
17.6
Exercise 2 solution 1 (dimensions are in millimetres).
Comments
In
Fig. 17.2
on page 45:
1. The standard used for the welding symbols has not been identi-
fied. There are clear indications that it is to ANSI/AWS.
A
the process abbreviation in the fork is alphabetical and the
weld symbol is for a stud weld.
B
,
C
and
D
these are melt through symbols and the symbol for
grinding.
B
and
D
these are radiographic test symbols.
2.
D
these symbols depict a single-V groove weld with melt
through, ground flush inside and radiographed.
B
and
3.
C
this symbol depicts a single-bevel-groove weld, stub pipe only
bevelled (set-on branch, with melt through, ground flush inside).
Figure 17.6
shows the circled symbol of
E
for ease of reference. This
is a fillet weld, of 6 mm leg length, on both sides of a flange to tube
joint.