Agriculture Reference
In-Depth Information
the 1/4-inch lag bolts and washers, and then loosen the Allen
screws in the sheaves so that the shaft is even with the end of
the left-hand bearing and projecting a few inches out of the
right-hand bearing. Make sure the Allen screws on both
bearings are facing left and that the drum is centered and
moves freely; then tighten down the Allen screws on the
bearings and sheaves. Finally, attach the large spoked sheave
to the right side of the shaft with the Allen screw facing to the
right.
Recycled 2 × 6 board with hook and hardware.
10 Place the entire machine on a stable flat surface with the
drum portion hanging off the edge. Run a V-belt between the
sheave on the motor and the sheave that rotates the drum.
Adjust the sheaves on their respective shafts until both are in
the same plane. Then attach a bungee cord between the two
steel loops to keep tension on the belt. Depending on your
arrangement, you may need to use an alternative such as steel
wire and a turnbuckle for tensioning.
Search WWH ::




Custom Search