Database Reference
In-Depth Information
Setting up logging to the syslog server is similar for both versions, via command line. Just execute the following
command:
set /SP|CMM/clients/syslog destination_ip=syslog_server_
SNMP alerts can also be set up in a similar fashion. The SNMP service is enabled by default and is configured
dependent on the target SNMP trap receiving system. The ILOM supports SNMP protocols v1, v2c, and v3. SNMP
protocols v1 and v2c use communities as the authentication method. A default read-only community named
public
and a read/write community named
private
are pre-created on the ILOM. A customized string can be used to send
SNMP traps, if needed, depending on the environmental setup. SNMP protocol v3 requires username/password-based
authentication.
SNMP is set up in a similar fashion in both ODA V1 and X3-2. On X3-2, the settings are accessible under
the following menu option: ILOM Administration
➤
Management Access
➤
SNMP. On V1, go to Configuration
Management
➤
System Management Access
➤
SNMP. Figure
2-7
shows the settings screen that you are taken to.
Figure 2-7.
SNMP settings screen
