Graphics Reference
In-Depth Information
this command (Click
Home > Feature > Hole
on the ribbon) and you will notice that a
dialog pops up. There are options in this dialog that make it easy to create different types
of holes.
Simple Hole
To create a simple hole feature, select
Type > General Hole
on the
Hole
dialog. Under the
Form and Dimensions
section, select
Form
>
Simple
. Type-in a value in the
Diameter
box and select the
Depth Limit
type. If you want a through hole, select
Depth Limit >
Through Body
. If you want the hole only up to some depth, then select
Depth Limit >
Value
, and then type-in a value in the
Depth
box. If you want a V-bottom hole, then type-in
a value in the
Tip Angle
box.
On the dialog, click
Specify Point
, and then click on a face. Place points on the face and
add dimensions to define their position. On the ribbon, click
Home > Sketch > Finish
.