Hardware Reference
In-Depth Information
FIGURE 6.35
The substrate is mounted properly and ready to process.
Next, to power up the open-source laser welder and the associated communications, do the
following:
1. Disconnect USB cable as shown in
Figure 6.36
.
2. Turn on the power supply shown in
Figure 6.37
(
Do not connect the USB cable before this!
).
3. Connect the USB cable.
4. Turn on TECSource 5305 (shown in
Figure 6.38
), wait until it boots, and then press Output.
5. Wait until it stabilizes at the temperature set point (currently 25°C).
6. Turn on 4320 LaserSource as shown in
Figure 6.39
.
7. Open the Hydra GUI and click on “connect” as shown in the screenshot in
Figure 6.40
.
8. If you receive this error message (e.g.
Figure 6.41
), restart the program and reset the Ardu-
ino (
Figure 6.42
), and then click on “connect” again.
9. Connected (
Figure 6.43
)
and ready for use!
Search WWH ::
Custom Search