Hardware Reference
In-Depth Information
1. Open the safety doors.
2. Carefully remove the aluminum + glass slider as shown in Figure 6.32 .
3. Remove the glass.
4. Place the plastic layers (two the first time and adding one per weld routine if more than
two).
5. Stretch the plastic layers flat/cold weld with rolling pin and make sure that they are touch-
ing each other with as few wrinkles as possible. Alternatively, you can pin them down over
the edges.
6. Put the glass on it.
7. Slide the arrangement back to the box carefully to not break the laser mount (see details in
Figures 6.33 and 6.34 ) .
8. When the substrate is mounted properly as seen in Figure 6.35 , close the box and put on the
safety glasses .
FIGURE 6.32 The aluminum + glass slider.
 
Search WWH ::




Custom Search