Hardware Reference
In-Depth Information
FIGURE 5.47 Soldering wire to the front metal contact on the heated board.
Zip tie the wires to the heated board to ensure you do not stress the soldered joints as shown
in Figure 5.48 . Now depending on the motors you have, you may need to solder extensions
to any wires that are necessary to ensure they can reach to the Melzi without running into the
moving parts. Then heat shrink tube over them to clean them up or you can braid all your
wires. In general, it is a good idea to have tidy wire management and spending a few extra
minutes will save you from frustration in the future when you break a connection because a
wire was out of place and got pulled by the printer.
 
Search WWH ::




Custom Search