Hardware Reference
In-Depth Information
FIGURE 5.20
Mounted coupler and the
z
-axis threaded rod.
Release the
x
-axis back onto the nuts as shown in
Figure 5.21
. Use three small zip ties to
tie the
x
-axis stage to the three bearings. Next, mount the pulley to the
x
-axis stepper motor
with M3 trap nuts and M3 × 10 grub screws and mount the motor with three M3 × 10 screws
as shown in
Figure 5.22
. Cut 875 mm of belt and atach the belt terminator as seen in
Figure
get it to lock in tightly. Run the belt through the pulley on the motor side and then the idler
Search WWH ::
Custom Search