Hardware Reference
In-Depth Information
FIGURE 5.12
Motors installed on the motor mounts and smooth rods installed for the
z
-axis.
5.2.6 The
x
-axis (left-right)
First, obtain all the
x
-axis components shown in
Figure 5.13
. Then, assuming that the printed
parts you are working with are not perfect, clean up motor end of the
x
-axis with a knife for
needle-nose pliers as seen in the yellow parts of
Figure 5.14
,
which show before (right) and
after cleaning (left). You also need to use a knife to dig out a hole in the big nut trap, but us-
ing a drill bit is usually easier. Load M3 nuts into the
x
-axis and use a threaded rod to push
through to the botom and then thread the screw for both of the deep nut traps as shown in
Search WWH ::
Custom Search