Stairs, Ramps, and Railings - Autodesk Revit Architecture 2015 Essentials - page 100

8. Click Edit Type to open the stair Type Properties.
9. Under Risers, uncheck the End With Riser parameter and click OK to
close the dialog.
This will remove the riser that is generated at the end of the stair.
10. Click Finish Edit Mode to complete the stair.
Ignore any warnings received about actual number of risers created.
11. Select the two railings that were automatically created, and swap the
type in the Type Selector to Glass Panel - Bottom Fill. The completed
stair is shown in Figure 4.14.
FiGure 4.14 Completed sketch-based stair
In the following exercise you will customize an existing Stair by Component
landing to reflect changes to the design.
exercise 4.4: Customize and Create a
Component Stair Landing
To begin, go to the topic's web page at www.sybex.com/go/revit2015essentials ,
download the files for Chapter 4, and open the file c04-ex-4.4start.rvt .