Information Technology Reference
In-Depth Information
■
debug ephone state:
Displays state debugging for Cisco IP phones.
■
debug ephone detail:
Displays detailed debugging for Cisco IP phones.
■
debug ephone error:
Debugs error conditions for Cisco IP phones.
■
debug ephone statistics:
Debugs call statistics for Cisco IP phones.
■
debug ephone pak:
Displays at a voice packet level (the contents of one in every 1024 packets are displayed).
■
debug ephone raw:
Provides low-level protocol debugging for all Skinny Client Control Protocol (SCCP) messages.
■
show ephone:
Shows the Cisco IP phones that have already registered.
Voicemail Integration
It is also possible to configure voicemail integration for phones at remote sites during a loss of direct connectivity to the central site
CUCM.
Voicemail integration can be configured using the following steps:
Step 1.
Specify the voicemail number.
Step 2.
Configure call forwarding to voicemail.
The voicemail pilot number can be configured as follows:
call-manager-fallback
voicemail 955512345678
The
voicemail
phone-number
command is used to configure the number that is speed dialed when a user presses the Messages button
on a Cisco IP phone. During normal operation, CUCM is configured with the voicemail pilot number, and this is used when the
Messages button is pressed. But, when using SRST mode, the router must route calls to the central site voicemail system over the
public switched telephone network (PSTN) using the number specified with the
voicemail
command.
